Phosphodiesterase I 抗体 (Biotin)
适用: Rattlesnake
ELISA, WB, IHC, DB, ICC
宿主: 兔
Polyclonal
Biotin
-
- 抗原 See all Phosphodiesterase I products
- Phosphodiesterase I
- 适用
- Rattlesnake
-
宿主
- 兔
-
克隆类型
- 多克隆
-
标记
- This Phosphodiesterase I antibody is conjugated to Biotin
-
应用范围
- ELISA, Western Blotting (WB), Immunohistochemistry (IHC), Dot Blot (DB), Immunocytochemistry (ICC)
- 特异性
- Cross-reactivities against enzymes of other sources may occur but have not been determined.
- 产品特性
-
The reagents were evaluated for potency, purity and specificity using most or all of the following techniques: immunoelectrophoresis, cross-immunoelectrophoresis, single radial immunodiffusion (Ouchterlony), block titration, ELISA, immunoblotting and enzyme inhibition.
Physicochemical characteristics: IgG protein concentration 10 mg/ml. Biotin/ IgG protein molar ratio (B/P) approximately 5.5. No foreign proteins added. Marker N-Hydroxysuccinimidobiotin. - 纯化方法
- The IgG (7S) fraction is prepared from the antiserum by ammonium sulphate precipitation and ion exchange chromatography.
- 免疫原
- Phosphodiesterase I isolated and purified from crotalus durissus terrificus. Freund's complete adjuvant is used in the first step of the immunization procedure.
-
-
- 应用备注
- Working dilutions in non-precipitating antibody-binding techniques may vary widely, but may be between 1/1,000 and 1/30,000.
- 说明
-
Physical form: Biotin-coupled hyperimmune rabbit IgG lyophilised from a solution in phosphate buffered saline (PBS, pH 7.2).
Conjugation procedure: A proprietary technique for the binding to biotin is used, followed by several purification steps. After each step activity and specificity are tested in a variety of techniques. The conjugate is lyophilised to assure stability and long shelf life. - 限制
- 仅限研究用
-
- 状态
- Lyophilized
- 缓冲液
- Phosphate buffered saline (PBS, pH 7.2). No foreign protein added.
- 储存液
- Without preservative
- 注意事项
- The lyophilised conjugate is shipped at ambient temperature and may be stored at +4°C, prolonged storage at or below -20°C. It is reconstituted by adding 1.0 ml sterile distilled water, spun down to remove insoluble particles, divided into small aliquots, frozen and stored at or below -20°C. Prior to use, an aliquot is thawed slowly at ambient temperature, spun down again and used to prepare working dilutions by adding sterile phosphate buffered saline (PBS, pH 7.2). Repeated thawing and freezing should be avoided. Working dilutions should be stored at +4°C, not refrozen, and preferably used the same day. If a slight precipitation occurs upon storage, this should be removed by centrifugation. It will not affect the performance of the product.
- 储存条件
- 4 °C
-
- 抗原
- Phosphodiesterase I
- Abstract
- Phosphodiesterase I 产品
- 背景
- This product is intended for use in precipitating and non-precipitating antibody-binding assays (such as e.g., ELISA and Western blotting and immunofluorescence or histochemical techniques).
-
You are here:
